www.EasternYachts.com | New Cromarty Yachts | Sailing Boats | Cutters and Sloops | Schooners, Ketches and Yawls | Motor Sailers | Classic Yachts | Classic Motor Cruisers | Motor Yachts | Project Boats | Sell your Boat

"Queenie Rose of Swansea"   Bruce Roberts steel ketch  Lying  Port  Gruissan,  France

 
Home
Sails and Deck Gear
Cockpit
Layout
Saloon
Galley
Nav Station
Forecabin
Aft Cabin
Engine
Specifications
Comments

Sails and Deck Gear

QUEENIE ROSE has a teak laid flush deck. The decking is laid over marine plywood which is secured to the steel deck. She is ketch rigged with self furling (in mast) mainsail and a self furling genoa / yankee foresail. All control lines run back to the cockpit for the mainsail and foresail. The aft mizzen sail is hoisted at the mast – just aft of the cockpit.

Sails

All sails were made by Dolphin Sails in 1996. 
Main, “in mast” reefing, controlled from the cockpit.
Genoa, Roller reefing 
Storm Jib
Yankee 
Cruising Chute
Staysail

Winches – 

2 x Lewmar 54’s (self tailing) for Genoa sheets located on both sides of the cockpit
1 x Lewmar 40 for control of main furling system located on the cabin roof in the wheelhouse
2 x Lewmar 40’s – one located on each mast

Anchoring equipment. 

There are 2 main anchors – a 60 lb CQR and 45 lb Delta. The Delta is permanently attached with a cable of 60 metres of chain and 25 metres warp. There is also a Lofrans electric anchor winch – with UP and DOWN  buttons on the deck by the anchor. The anchor winch is connected to the 12v system via a separate circuit breaker 

 

Click here for more: - [ Home ] [ Sails and Deck Gear ] [ Cockpit ] [ Layout ] [ Saloon ] [ Galley ] [ Nav Station ] [ Forecabin ] [ Aft Cabin ] [ Engine ] [ Specifications ] [ Comments ] 
    For further details or to arrange to view, please contact Adrian  Espin at: - Astonbury Marine Services 
19 Colne Road, Brightlingsea, Essex, CO7 0DL  Tel: Freephone 0800 068 6190 or +44 1206 305 996   
or email to: adrian@EasternYachts.com
 In this case we are acting as Brokers only. The Vendor is not selling in the course of a business. Whilst every care has been taken in their preparation, the correctness of these particulars is not guaranteed. The particulars are intended only as a guide and they do not constitute a term of any contract. A prospective buyer is strongly advised to check the particulars and where appropriate at his own expense to employ a qualified Marine Surveyor to carry out a survey and/or to have an engine trial conducted.